The new standard for rc-car online magazines

area52

you are here: Home :: News :: Xray NT1'13 announced

Xray NT1'13 announced

Xray announce the release of the NT1'13 200mm nitro on-road kit. The updated '13 spec car is based on an all-new super narrow 2.5mm alloy chassis and features new shorter low-profile dampers with fixed delrin shock pistons, new low-profile shock towers, revised upper bulkhead parts with updated roll centre, a front wire-type anti-roll bar, new lightweight drivetrain parts and rear dogbone driveshafts. Also new is a reverse-type clutch with updated flywheel, new alloy wheel hubs and a new independent muffler mounting.

Features:
- All-new Low Profile (LP) shocks
- All-new lower shock bodies
- All-new shorter shock rods
- All-new fixed Delrin pistons
- All-new Short Shock Springs (3S)
- All-new lowered shock towers
- All-new upper bulkhead clamps with new roll centers
- All-new front wire anti-roll bar
- All-new narrow chassis
- All-new Mutli-Flex™ radio plate
- All-new Reverse Clutch set
- All-new reverse flywheel
- All-new flywheel disk
- All-new independent muffler mounting
- All-new longer muffler wire
- All-new front left bulkhead
- All-new front lower arms with anti-roll bar mount
- All-new foam bumper for wire anti-roll bar
- All-new alu wheel hubs
- All-new car holder with eyelet
- New ligtweight front middle shaft
- New lightweight front diff outdrive adapters
- New ligthweight rear diff outdrive adapters
- New rear dogbone drive shafts

Link: Xray NT1'13

 

Share this article or page on your prefered social network:

Share |
Banner
Banner
Banner

Banner

Banner
Buy RC Dirt Bags Online
Banner